Check the profile first, then the card, then the phone.
Try this first
- Open your profile link or scan your QR code. If that fails too, fix the profile first (still a Draft?).
- In NFC Products, select Test My NFC Link on the card — it shows whether a tap works right now and what it opens.
- Wake and unlock the phone. On Android, switch on NFC in Settings.
- iPhone: hold the card near the top edge. Android: reader position varies by model — try the top or middle of the back, moving slowly.
- Remove thick, metal or magnetic cases.
- Try another phone, and share your QR code meanwhile.
Find the cause
-
Does your profile open when you use your public link or scan your QR code?
- Yes: Your profile works, so the problem is between the card and the phone. Go to the next question.
- No: Fix the profile first. If the page says “Profile not found”, your profile is most likely still a draft: go to Overview and select Publish profile. See My profile says Draft or “Profile not found”.
-
Does Test My NFC Link say a tap works?
In NFC Products, select Test My NFC Link on the card. It shows what a tap opens right now, without counting a visit in your Analytics.
- Yes: The card is set up correctly. Go to the next question.
- No: The test names the problem. Switched off, or Lost or stolen and you found it: select Switch back on. Locked by Card2Tap: contact us. The profile isn’t published: publish it on Overview. No profile chosen, or the profile was deleted: choose one under Profile it opens and select Change profile, or select Give it its own profile. Not activated yet: see How do I activate my Card2Tap product? For the messages a tap shows, see My card shows a message instead of my profile.
-
Is the phone’s screen on and unlocked, with NFC switched on?
- Yes: Go to the next question.
- No: Wake and unlock the phone. On Android, open Settings, search for “NFC” and switch it on. On an iPhone there is usually nothing to switch on: when the card is read, a notification appears at the top of the screen, and you tap it to open the profile.
-
Are you holding the card flat against the back of the phone, near the top, for a few seconds?
- Yes: Go to the next question.
- No: The phone’s reader is small. Hold the card flat against the back of the phone near the top and keep it still for two or three seconds. On some Android phones the reader is in the middle of the back, so move the card slowly. Thick cases, metal cases, magnetic mounts and cards kept behind the phone can block the signal: take the phone out of its case and try again.
-
Does the card work on another phone?
- Yes: The card is fine. The first phone probably has NFC switched off, a case in the way, or no NFC reader. People can always scan your QR code or open your link instead.
- No: If Test My NFC Link says a tap works but no phone reacts to the card, the card itself may be damaged. Contact us with your order number and the card’s product reference. In the meantime, share your QR code from Share & QR.
You never need to reprogram a card when you change your profile or your web address. Each card has its own permanent NFC link that opens the profile you choose for it in NFC Products.
Still not working?
Contact Support and tell us your order number, your profile address and which phone you tried. We will never ask for your password.
